Materials Embedding

Resin 613LT is an epoxy resin which cures without temperature rise, ideally suited for samples that would be degraded by heating during polymerisation. Free from carcinogens, mutagens and reprotoxins.

613F Resin is a fast-curing epoxy resin, 2 to 3 hours, designed for use on materials that can withstand temperatures up to 140 °C. Free from carcinogens, mutagens and reprotoxins.

613 Resin is a multi-purpose resin with a limited exothermic temperature of 50 °C* and a curing time of 10 hours. Free from carcinogens, mutagens and reprotoxins.

Acrylic cold mounting resins for microelectronics, optics and micro engineering applications.

Methyl-Methacrylate cold mounting resin for common materials.

Methyl-Methacrylate transparent cold mounting resin for precision parts.

Polyester cold mounting resins for metal surfaces and very hard materials.

Methyl-Methacrylate cold mounting resins in 5 transparent colours to simplify the classification of samples.

Methyl-methacrylate resin 665 is a cold setting resin designed for sample recovery.

Flexible cylindrical cold mounting moulds are available in all standard diameters for central and individual pressure sample holders.

Flexible rectangular cold mounting moulds, designed for use with cold mounting resins.

Moulds with a removable bottom for use with transparent cold mounting resins 601.2, 609 and 603.

Ceramic balls used as a base for either hot or cold mounting resins.

SamplKwick® is a semi-transparent, high viscosity rapid curing acrylic cold mounting compound.

EpoKwick™ is a transparent, quick setting epoxy resin that cures in 90 minutes.

A free flowing, low viscosity, low shrinkage epoxy resin that is ideal for use with porous and heat sensitive samples.

Metal clips ideal for holding thin samples during cross-sectioning.

VariDur 10 is a high hardness, high viscosity, semi-transparent, acrylic cold mounting compound with superior abrasion resistance and edge retention.

A low viscosity epoxy cold mounting system curing at room temperature.

The Scan-Dia system offers a complete range of cold setting, metallographic embedding agents and accessories.

2-part plastic embedding moulds, 1in (25.4.mm), 1 1/4in (32mm) and 1 1/2in (38mm) diameters.

Reusable moulds for cold embedding, made from sturdy, flexible white or blue silicone which does not deform over time.

Demotec 70 is a conductive two component resin based on methyl methacrylate and electrically conductive carbon.

Fluorescent contrast dye to be mixed with clear mounting resins, which highlights porosity and micro-cracks.